Yet Another iDevice Dock

After printing many Phone and Watch stands, I couldn't find one that worked with my particular case, my phone and tablet, and the watch horizontally. It just seemed that everything I found was designed for a specific use that wasn't mine.

This design isn't overly constrained. It could hold an android phone or tablet if you desired, and it's appropriate for many different case designs.

It's designed to print vertically (rotate around the X axis 90 degrees), with no support, and 10% infill (so as not to waste filament). It should fit most build plates as a result, and was designed to not tip over with a reasonably heavy tablet.

There's a groove in the bottom for multiple cables (often a hassle with other designs), and while your device doesn't dock, per se, it will organize your devices in a relatively small space on your nightstand.