Thingiverse
Yet another Micro SD storage case
door FabioFontes
2
Downloads
2
Likes
0
Makes
Just one of those "Why am I browsing Amazon, I can just make one!" moments. So I did!
**The slots inserts are meant to be printed in TPU** for them snuggies. Also because I had spools of it and couldn't be arsed working out tolerances and potentially damage the cards with hard plastic scraping about. Also that logo needs supports for how wide them letters are. Unless you use the blank one I suppose, then it's fine.
For assembly, the hinge can just be pushed into place. It helps if you "close" it on the other end and press the two halves together.
**The slots inserts are meant to be printed in TPU** for them snuggies. Also because I had spools of it and couldn't be arsed working out tolerances and potentially damage the cards with hard plastic scraping about. Also that logo needs supports for how wide them letters are. Unless you use the blank one I suppose, then it's fine.
For assembly, the hinge can just be pushed into place. It helps if you "close" it on the other end and press the two halves together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
