Yet another shelf legs

This is just another leg design for shelf Please note: The build plate MUST be cleaned before print plate #2, as this is tall print but with very little contact surface to the build plate.When print this with PETG, beware that PETG can be building up a big blob outside on nozzle and it will be dropped somewhere haftway printing, then nozzle runs accross this blob on the next layer and will likely to knock the print off the build plate.If your filament does that, just print 2 legs at the same time to be safe.You will need 4x M4 chip-board screws and 1x M6 button head screw (the same screws used on most gaming chair)Use epoxy glue to glue the M6 screw to the mount plate securely.Tap the M6 thread on the cylinder, if not it would be hard to screw in and the screw would spin around in place.