Thingiverse
Yet Another Smart LCD Stand
von tkbletsc
17
Downloads
10
Likes
0
Makes
After digging through the dozens of Smart LCD cases and holders, I somehow didn't find one that fit what I was doing -- mounting one at an angle on a flat wood surface. So I made this.
It elevates the LCD about 80mm and inclines it 30 degrees. Attach LCD to brackets with #4x1/2 sheet metal screws (or similar), attach brackets to surface with screws of your choice (#4 or #6-ish).
Note: the knob shown is [this one (small)](https://www.thingiverse.com/thing:1340247).
It elevates the LCD about 80mm and inclines it 30 degrees. Attach LCD to brackets with #4x1/2 sheet metal screws (or similar), attach brackets to surface with screws of your choice (#4 or #6-ish).
Note: the knob shown is [this one (small)](https://www.thingiverse.com/thing:1340247).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
