Yet another Spool holder (horizontal)

Yes this is yet another spool holder design, I give Credit for the idea to the "Flsun Q5 filament spool holder v2 (horizontal) by alexeyzel August 22, 2020" https://www.thingiverse.com/thing:4576600
which i printed and used for quite some while on my Flsun Q5, to a lot satisfaction,
Only thing that was bad on his design was that i had a lot more Spools with different sizes in the spool holes and printing for each one a support was not something i was willing to do, and without it tented to fall off.
So i thought what would i make different, and the First answer was what if i make a cone-shaped top that i can put on his design,and this worked and works very good on the flsun.
I was about to put that up on Thingiverse when i thought i would like to have the same on my CR-10S And how about 2 Cones on the bottom and top of the turntable. As result i created This design. it fits spools with hole diameter of 3.1cm to 99,9cm

It is set up that together with the Turntable it will fit as