Thingiverse
(yet another) Umbrella Holder
door cajtar
10
Downloads
7
Likes
0
Makes
Umbrellas had fully taken over the closet. With their aggressive posture, stiff demeanor, pointed attacks and delicate webbed sides, they had simultaneously wreaked havoc on the closet floor and also were prone to damage.
After scouring the interwebs for just exactly the right umbrella holder, and not finding it, I set out to create my own because well, why not.
Description
=========
This one mounts four full size umbrellas vertically against a wall.
The bottom piece (_Foot_) has individual small pockets to locate each umbrella tip, and a perimeter lip to catch any remaining water on the 'brella allowing it to spread out and dry. The bottom flits up against the baseboard (16mm wide in my closet). I used painter's tape on the wood floor, and stuck the base down to the painter's tape with double sided tape. This way the floor isn't damaged if I need to move it.
The top piece (_WallClip_) mounts to the wall ~600mm directly above the bottom. It has long fingers which
After scouring the interwebs for just exactly the right umbrella holder, and not finding it, I set out to create my own because well, why not.
Description
=========
This one mounts four full size umbrellas vertically against a wall.
The bottom piece (_Foot_) has individual small pockets to locate each umbrella tip, and a perimeter lip to catch any remaining water on the 'brella allowing it to spread out and dry. The bottom flits up against the baseboard (16mm wide in my closet). I used painter's tape on the wood floor, and stuck the base down to the painter's tape with double sided tape. This way the floor isn't damaged if I need to move it.
The top piece (_WallClip_) mounts to the wall ~600mm directly above the bottom. It has long fingers which
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
