Yg300 mount

This all mount is for the Yg300 mini projector. the degree of angle can be controlled by a zip tie and the hing can use 1.75mm filament for the pin. just melt the two ends before toy mount on the wall or ceiling. This is still a work in progress for fine tuning, but well function.

Still need to add:
-An optional 10,20,30,45,60 degree angle block (Still keeping the zip tie mount)
-Slim down the plastic used to save on filament(1/2(.5)LB at 20% infill for every thing)
-....ect


If there are any suggestions or thing you like/dislike please comment.