Thingiverse
Yin Yang Cats Set
door C47_3D
658
Downloads
689
Likes
1
Makes
**Yin Yang Cats** as a*
- fridge magnet / coin
- bookmark
- earring
- keyring
- as decoration for wrist strap (bracelet)
etc.
Original size is ~39mm x 47mm (or little more with rings)
Bookmark ~ 14 x 3,5cm
---
Model is based on cats drawed by NekoSan, made and uploaded with her permission
https://www.instagram.com/p/CVI7CXZsxPn/
---
Use two colors (white, then black) or three (pink, white, black) - or different light / dark colors
With original size change color after each 0.6mm (or just after 1,2mm if using two colors)
Bookmarks are only 2 colors and should be printed with 0.1mm layer hight - as they are 0.6mm height (original) and 0.4mm hight (inverted). You can resize it to be thicker and use 0.2mm (or different) layer height then
The smallest printable size with 0.4mm nozzle should be 75%
You can print it for earrings as it will weight much less (you can leave 100% on X and Y axis for better colors)
Name 'ring_white' means that the ring is between
- fridge magnet / coin
- bookmark
- earring
- keyring
- as decoration for wrist strap (bracelet)
etc.
Original size is ~39mm x 47mm (or little more with rings)
Bookmark ~ 14 x 3,5cm
---
Model is based on cats drawed by NekoSan, made and uploaded with her permission
https://www.instagram.com/p/CVI7CXZsxPn/
---
Use two colors (white, then black) or three (pink, white, black) - or different light / dark colors
With original size change color after each 0.6mm (or just after 1,2mm if using two colors)
Bookmarks are only 2 colors and should be printed with 0.1mm layer hight - as they are 0.6mm height (original) and 0.4mm hight (inverted). You can resize it to be thicker and use 0.2mm (or different) layer height then
The smallest printable size with 0.4mm nozzle should be 75%
You can print it for earrings as it will weight much less (you can leave 100% on X and Y axis for better colors)
Name 'ring_white' means that the ring is between
C47_3D publiceert ook op
66 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
