Yoghurt Holder

Thanks to the original creator for the great idea here!
I added a hole in the bottom so it can fit a wider range of yoghurt containers out there, actually i think it fits all of them now.

Tested this with the usual yoghurt we buy here in Sweden and works great.
We now waste almost no yoghurt if you let it stand a few hours at room temperature.

Trying to fold the end and roll or even squeeze out yoghurt does not get it all out so there is still a lot of waste.

This standing method is the best, unless of course you want to cut open the container and lick out the rest!

Added hole in TinkerCAD then printed on a Raise3D E2 machine with 0.2 layer height and 25% infill but its so thin so i don't think infill matters. Just make your walls 2.5 or 3.5.