Thingiverse
Yongnuo YN360 Light Diffuser
door fallschirm
1
Downloads
1
Likes
0
Makes
This is a diffuser for Yongnuo YN360 (square body). The YN360 comes with a orange diffuser which does not meet my needs. Thats why I created this slide on white diffuser from PETG.
It was printed on an Anycubic Mega X (300x300mm) and was 45° angled to fit the printbed.
For the best diffusing results I recommend 3D cross infill at 30% infill amount.
I printed with 260°C and 80°C bed in an enclosure, you might need to tweak these settings to get propper adhesion. 40mm/s seemed to work pretty well and gave good results in an acceptable time (~8 hours). I used 0.2mm layer height.
It was printed on an Anycubic Mega X (300x300mm) and was 45° angled to fit the printbed.
For the best diffusing results I recommend 3D cross infill at 30% infill amount.
I printed with 260°C and 80°C bed in an enclosure, you might need to tweak these settings to get propper adhesion. 40mm/s seemed to work pretty well and gave good results in an acceptable time (~8 hours). I used 0.2mm layer height.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
