Thingiverse
YubiKey 5C Case
von anophoo
2
Downloads
1
Likes
0
Makes
This is a remix. Just print it as it is. Normal mode should be enough. Then you can glue it up together.
Tested on PLA and Polyflex materials. Both works with 40-60% infill.
Tested on PLA and Polyflex materials. Both works with 40-60% infill.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!