Thingiverse
Yuneec Q500 External Camera Cable Mounting Bracket
von Looney
36
Downloads
28
Likes
2
Makes
This is a Bracket to mount the External Antenna Wire after the CGO2 has been modified with a 30 cm Ufl to RP-SMA Antenna Wire this Wire will come from the Camera to the rear of the Yuneec Q500 Drone.
How to install:
This Bracket should be epoxied to the bottom of your Q500 and also has a optional pilot Hole to add a screw for an additional way to secure the Bracket to your Q500.
Printed in ABS at 80% Infill.
Additional Hardware needed:
1 x Tube Plastic Epoxy
1 x 30 cm Ufl to RP-SMA Antenna Adapter Cable
1 x 2.4 GHz Cloverleaf Polarized Antenna
1 x #8 1/2" Screw (Optional)
How to install:
This Bracket should be epoxied to the bottom of your Q500 and also has a optional pilot Hole to add a screw for an additional way to secure the Bracket to your Q500.
Printed in ABS at 80% Infill.
Additional Hardware needed:
1 x Tube Plastic Epoxy
1 x 30 cm Ufl to RP-SMA Antenna Adapter Cable
1 x 2.4 GHz Cloverleaf Polarized Antenna
1 x #8 1/2" Screw (Optional)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
