Thingiverse
Z adjustment wheel
von Blackpanther_st
3
Downloads
1
Likes
0
Makes
This is the Z adjustment wheel I designed for my DIY drill press to mill conversion.
I started with a functional plastic prototype, and then milled out a steel one using the DIY mill with the plastic prototype.
Very comfortable on the fingers; it just makes you want to use it!
In my application I threaded the center to 1/2" UNF (20tpi) to match the lead screw.
I believe it would work for UNC thread as well. also this could be used as an adjustment knob at the end of a shaft as well.
If you like my work, please hit "like" and check out my other uploads as well.
I have also included the FCStd file as well, in case you need to edit the dimensions for your application. FCStd is the native FreeCAD working file format.
I started with a functional plastic prototype, and then milled out a steel one using the DIY mill with the plastic prototype.
Very comfortable on the fingers; it just makes you want to use it!
In my application I threaded the center to 1/2" UNF (20tpi) to match the lead screw.
I believe it would work for UNC thread as well. also this could be used as an adjustment knob at the end of a shaft as well.
If you like my work, please hit "like" and check out my other uploads as well.
I have also included the FCStd file as well, in case you need to edit the dimensions for your application. FCStd is the native FreeCAD working file format.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!