Thingiverse
Z axis endstop spacer
von Craigers3D
17
Downloads
9
Likes
0
Makes
This works on the Folgertech 2020 prusa, I'm not sure about other Prusa variants.
No matter what endstop I used, the endstop would slowly slide down print after print unitl the nozzle would crash into my build plate. So I made a spacer to keep it from sliding down. Quick and simple.
I'm using the Stronger Z endstop (http://www.thingiverse.com/thing:1177943) from http://www.thingiverse.com/pjvpjv .
Along with the Adjustable Z endstop (http://www.thingiverse.com/thing:1261300) from http://www.thingiverse.com/Joe558
No more slow creep downward!
No matter what endstop I used, the endstop would slowly slide down print after print unitl the nozzle would crash into my build plate. So I made a spacer to keep it from sliding down. Quick and simple.
I'm using the Stronger Z endstop (http://www.thingiverse.com/thing:1177943) from http://www.thingiverse.com/pjvpjv .
Along with the Adjustable Z endstop (http://www.thingiverse.com/thing:1261300) from http://www.thingiverse.com/Joe558
No more slow creep downward!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
