Thingiverse
Z-axis floating-nut-arrester (Thicker)
von JadeKnight
4
Downloads
2
Likes
0
Makes
I thickened the 'top' wall over the nut to about 3mm. This increases the strength of the whole assembly, and holds the nut very well without damaging the arrester.
Looking at the picture, you can see the change made in the bottom of the one on the right.
Looking at the picture, you can see the change made in the bottom of the one on the right.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
