Thingiverse
Z axis probe holder for solidoodle
par mikegi
7
Téléchargements
2
Likes
0
Makes
Probe holder for solidoodle.
**Note: My measurement for the X axis rod spacing was a tad off.. needed to file the slots a little bit.**
OpenSCAD included if you wish to customise.
Mounts on the x-axis.
Use 4 - 5 mm diameter bolt and nut (and perhaps a spring) to clamp to the x-axis rods.
Just fits between the belts. The smaller part could be a bit thinner in the next revision.
**Note: My measurement for the X axis rod spacing was a tad off.. needed to file the slots a little bit.**
OpenSCAD included if you wish to customise.
Mounts on the x-axis.
Use 4 - 5 mm diameter bolt and nut (and perhaps a spring) to clamp to the x-axis rods.
Just fits between the belts. The smaller part could be a bit thinner in the next revision.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !