Thingiverse
Z axis support
door SveGo
24
Downloads
13
Likes
0
Makes
Improve the stability of the Z axis using a wooden dowel as a connector.
Will improve z axis stability a lot. Uses a 10mm wooden Dowel for the connection, but any 10mm rod will do.
I used 3x12mm screws for the connection to the woorden board and into the dowel.
I use it on a Tevo Tarantula but will probably work with any printer using a 2020 frame.
Will improve z axis stability a lot. Uses a 10mm wooden Dowel for the connection, but any 10mm rod will do.
I used 3x12mm screws for the connection to the woorden board and into the dowel.
I use it on a Tevo Tarantula but will probably work with any printer using a 2020 frame.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
