Thingiverse
z-nut-lock for mpcnc
by chriswal
4
Downloads
2
Likes
0
Makes
this z-lock-nut i created because the nut was pushed out in the original lock from mpcnc.
this is for an M8 h=25mm d=11mm. this is for the old MPCNC. the nut is very hard to push in, but it worked at least for me.
this is for an M8 h=25mm d=11mm. this is for the old MPCNC. the nut is very hard to push in, but it worked at least for me.
chriswal also publishes on
33 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
