Thingiverse
Z-REX
door muzz64
6.5k
Downloads
4.6k
Likes
83
Makes
Z-REX's (pronounced "Zee - Rex") are small, easy and fun prints of a dinosaur model... with an opening mouth / jaws and teeth that bite.
No support required... just print it with at least 3 shells and 50% or more infill to make the jaws / mouth springy so they open and close.
At standard scale Z-REX's are 125mm long. You can safely uniformly scale them up (as this will increase internal clearances), but scaling them down may result in the mouth / jaws not moving.
Please refer to the images provided and print instructions for additional information... and post photos of your Z-REX's.
Z-REX's work in the same way as my SHARKZ / CROCZ / EAGLEZ etc. These prints can be found at:
'Bugz' http://www.thingiverse.com/thing:1904654
'Sharkz': http://www.thingiverse.com/thing:910216
'Ratz' http://www.thingiverse.com/thing:1532944
'Crocz' http://www.thingiverse.com/thing:941177
'Woodpeckerz' http://www.thingiverse.com/thing:1155168
'Eaglez' http://www.thing
No support required... just print it with at least 3 shells and 50% or more infill to make the jaws / mouth springy so they open and close.
At standard scale Z-REX's are 125mm long. You can safely uniformly scale them up (as this will increase internal clearances), but scaling them down may result in the mouth / jaws not moving.
Please refer to the images provided and print instructions for additional information... and post photos of your Z-REX's.
Z-REX's work in the same way as my SHARKZ / CROCZ / EAGLEZ etc. These prints can be found at:
'Bugz' http://www.thingiverse.com/thing:1904654
'Sharkz': http://www.thingiverse.com/thing:910216
'Ratz' http://www.thingiverse.com/thing:1532944
'Crocz' http://www.thingiverse.com/thing:941177
'Woodpeckerz' http://www.thingiverse.com/thing:1155168
'Eaglez' http://www.thing
muzz64 publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
