Thingiverse
Z rod alignment for Tarantula
von klauscon
15
Downloads
5
Likes
0
Makes
I designed this part to be added to the top z strain relief brackets by Tinic and ndupont. I also added the Oldham from IxMikeyxl as I found that the normal oldhams were a little too far out for the Taralu aluminium z mount. You will need a total of 2 608ZZ bearings for single z, 4 for dual z, but the overall solution makes aligning the z to be straight extremely easy.
You need to print
1x https://www.thingiverse.com/thing:2251730
1x https://www.thingiverse.com/thing:2379659 (if using dualz)
1 or 2 x https://www.thingiverse.com/thing:2227056 (depends if using dualz)
2x lock collars from nduponts files for the bottom bearings.
Instructions: print one, default if for LEFT side of printer (dual z), so mirror it if you only use a single z. If using dual z, print it twice and mirror it the second time.
You need to print
1x https://www.thingiverse.com/thing:2251730
1x https://www.thingiverse.com/thing:2379659 (if using dualz)
1 or 2 x https://www.thingiverse.com/thing:2227056 (depends if using dualz)
2x lock collars from nduponts files for the bottom bearings.
Instructions: print one, default if for LEFT side of printer (dual z), so mirror it if you only use a single z. If using dual z, print it twice and mirror it the second time.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!