Z Stabilizer

This is used to stabalize the z axis for Adimlab printers. It can be used to stabalize the z axis or other uses. Reduces the amount of print time and plastic that I've seen used with other z stabalizer braces.

When you print it out you can either tap the hole in the tie block or glue a wooden dowel pin in the hole. The hole size is 3/16 of an inch,which can be tapped out using a 1/4-20 tap if you are going to use all thread. You can easily buy a 3/16 dowel pin on Amazon or in a local hardware store and get it cut to length, just sand the ends before inserting to give a bit of a less tight fit. It won't take much to sand, just a small amount so when inserting the pin it doesn't crack the plastic if its really tight. I would recommend before gluing to ensure you measure the length needed as each printer is different and could be offset by as much as an 1/8 inch in length. No bolts needed as the pins accomodade a fit that helps to reduce vibrations.

Updated .. I added an addition