Z-stop relocation mount

This is a Z-axis endstop relocation mount for the Tristarbot M1 Printer. I created this mount when we upgraded the hot end to a Prusa housing for the E3D V6.

This mount will allow you to mount the endstop switch for the z-axis lower than the factory settings. This comes in handy with different hot end setups as they are shorter than the factory hot end for this printer.

I made the part with slots for the end-stop mount holes to allow you to move it in and out so it can be properly adjusted.

I printed the mount out of Nylon with a .15 layer height with 25% infill for rigidity. But realistically it could be printed with different settings. Id recommend not using PLA due to its fragile nature, and this needing to hold the switch in place so it can be pressed.

To mount the bracket, you will need an extra 3mm screw and square nut for the frame. I matched up the one that it came with for the factory mount.