Z-tower adjustable feet

Scouring Thingiverse after adjustable feet for the z axis tower that would compliment AzzA's Z braces to fit on my Duplicator I3 Plus proved to be difficult. There were similar designs to what I had in mind, but none in the same style of the original Z braces. I also was unable to further extend the width of my setup. So therefore I took this mission upon myself and this is the outcome.


For this you will need:

(8) M3x10 (DIN 912 / ISO 4762)
(4) M8 locking nut (DIN 985 / ISO 10511)
(2) 70 mm M8 threaded rod (DIN 976)


Installation:

Press a M8 locking nut into Bottom_Mount_G2 with the nylon facing upwards. Cut a M8 threaded rod to 70mm in length and thread it into Bottom_Mount_G2. Now insert a regular M8 (Locking nuts can be used but they are harder to turn) nut in the Adjustment_Knob_G2 and place the knob in its place inside the Foot_G2 with the plastic of the knob facing down and thread it all the way onto the threaded rod of the Bottom_Mount_G2 assembly. Unscrew the u