Z-Vice Turntable

I have purchased a second hand Z-Vice (they don't seem to make these anymore), and it did not come with several of the accessories.

This is a turntable (plus additional washer) for the Z-Vice. It should enable a few degrees more movement than the original Z-vice turn table, although it won't be as strong as an original alloy one.

Below is a YouTube link to the Z-vice so you get an idea what I'm on about (hope I'm allowed to post links here).

https://www.youtube.com/watch?v=LiGY1DCyjXY&t=81s

I haven't printed yet as I'm still waiting for the printer to arrive.

This is a work in progress, as I might alter the model and reduce the amount of pla used, by removing block material and just adding ribs to stiffen the part, or even make it a bit bigger once I've tried this out.


Size is 270mm long x 80mm wide x 32mm high

Using cura recommended settings (for a CR10) says 140g and about 9 hour print with 20% infill...