Thingiverse
Z18 Tool Holder
par krandon
1
Téléchargements
3
Likes
0
Makes
NOTE: Initial print using Simplify3D was too tight of a fit. Tailored the .skp and will try again on MakerBot Print.
Basic bracket to hold needle nose pliers on the side of the MakerBot Z18. 20mm opening should accommodate a variety of handheld tools.
I cut holes in the long face to hopefully save filament. Not sure if it was much better than leaving it flat faced with 10% infill.
Basic bracket to hold needle nose pliers on the side of the MakerBot Z18. 20mm opening should accommodate a variety of handheld tools.
I cut holes in the long face to hopefully save filament. Not sure if it was much better than leaving it flat faced with 10% infill.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !