Thingiverse
Z28 Center Cap
von JamieLucier
25
Downloads
14
Likes
0
Makes
These are center caps for GM rims. I printed them by swapping the filament during the print to get a different colour for the text. The installation tool fits a 1/2in ratchet. Press fit for 2 x 1/8in dowels.
The settings were a bit rough. Originally intended as a quick test fit part, but I stuck with it. Finer resolution would probably look better. Suggest 2mm wall on installation tool.
The settings were a bit rough. Originally intended as a quick test fit part, but I stuck with it. Finer resolution would probably look better. Suggest 2mm wall on installation tool.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
