Thingiverse
Zen Meteor
by WorstCat
58
Downloads
47
Likes
0
Makes
NEWEST UPDATE: 17 DEC 2019 - I added a great little threaded portion to the back end of the pistol FC group piece. There are some pretty sweet thread-in quick-disconnect sling cups made by Grovtec that I've decided to go with. Full-steel, and accepts the standard QD sling format of connector. This thing is big enough that you'll want a sling to take up the weight!
07 Dec 2019 - My fellow high caliber enthusiasts - I regret to inform you that I will not be doing any more development on this project... BECAUSE IT IS DONE. I have a few very small tweaks aimed at minimizing the hand-sanding that I've had to do, so hold off on starting any prints until Monday or Tuesday (DEC 9 or 10). But otherwise...the damn thing is finished, and it is beautiful. I printed the receiver with 7 shells, alternating an extra shell with each layer, and 50% infill. IT TOOK 143 HOURS TO PRINT...but damn was it worth it. Check the comments section for a new post with pics.
Fully assembled it is 58"
07 Dec 2019 - My fellow high caliber enthusiasts - I regret to inform you that I will not be doing any more development on this project... BECAUSE IT IS DONE. I have a few very small tweaks aimed at minimizing the hand-sanding that I've had to do, so hold off on starting any prints until Monday or Tuesday (DEC 9 or 10). But otherwise...the damn thing is finished, and it is beautiful. I printed the receiver with 7 shells, alternating an extra shell with each layer, and 50% infill. IT TOOK 143 HOURS TO PRINT...but damn was it worth it. Check the comments section for a new post with pics.
Fully assembled it is 58"
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
