Thingiverse
Zero G Calibration cube
by JusthinP
8
Downloads
13
Likes
0
Makes
We started modding the Ender 5, It became coreXY! We've named it "Zero G".
The Ender 5 Zero G is currently in beta, if you'd like to see the build, have any questions or would like to participate please visit our discord at https://discord.gg/gzJP2s8
The Zero G Calibration cube has been created include our logo and test the Zero G,
X and Y sides are marked as well as the logo, these should be 3mm deep, as well as a chamfered hole on the top and bottom, 1.80mm wide to test fit a piece of 1.75mm filament It should be a bit tight.
The Ender 5 Zero G is currently in beta, if you'd like to see the build, have any questions or would like to participate please visit our discord at https://discord.gg/gzJP2s8
The Zero G Calibration cube has been created include our logo and test the Zero G,
X and Y sides are marked as well as the logo, these should be 3mm deep, as well as a chamfered hole on the top and bottom, 1.80mm wide to test fit a piece of 1.75mm filament It should be a bit tight.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
