Thingiverse
Zero motorcycle logo
por middlenamefrank
6
Descargas
1
Likes
0
Makes
This is my rendition of the Zero motorcycle logo, one or two revisions ago....the version I like best!
This was one of my first SolidWorks exercises, and there are a few odd things about it. The scaling, in particular, is.....well, let's just say it's special. Cura auto-scales it by a factor of 10000% for me when I open it. But I figure you'll want to scale it for whatever you're going to use it for anyhow. I printed up a fairly large one (3-1/2" long) which I use as a zipper pull on my motorcycle jacket. It's nice because I can open or close my jacket with my gloves on now.
You'll notice that one side is flat, the other side has edges filleted. You'll want the flat side on the build plate, of course.
This was one of my first SolidWorks exercises, and there are a few odd things about it. The scaling, in particular, is.....well, let's just say it's special. Cura auto-scales it by a factor of 10000% for me when I open it. But I figure you'll want to scale it for whatever you're going to use it for anyhow. I printed up a fairly large one (3-1/2" long) which I use as a zipper pull on my motorcycle jacket. It's nice because I can open or close my jacket with my gloves on now.
You'll notice that one side is flat, the other side has edges filleted. You'll want the flat side on the build plate, of course.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!