ZeroG Hydra EMS Top Panel

******4/10/25: just realised i've messed up the rear panel mounting points (they're on the wrong face) so will address that ******

Just taken the ZeroG provided electronics enclosure top panel and thrown on a similar honeycomb pattern to the FT EMS panels so that it matches. I have pretty much eyeballed this and will be testing it later this week but its a starting point for people.
This is for the ender 5 pro so should also fit the Voron Trident 250.

Choose your own adventure for the print settings etc. Also check out FT's EMS panels et al cos hes done an amazing job and I've made this so that theres a similar panel to his available

Have also attached the honeycombed panel as a solid without the mounting points as well incase you want to try throw your own mounting points on (in case my ones are trash)

GG, EZ, TGIF, ILY

Edit 2/10/25: After test printing a corner of the previous iteration, found that the standard top panel is meant to fit over the 2020 extrusion as well so have re