Thingiverse
ZigStar OliZig Case
von elronzo
2
Downloads
0
Likes
0
Makes
As the Olimex ESP32-POE board I got is slightly longer than expected (see photo) I had to do a little redesign.
I also had make the box a little bit higher as the Zigstar-Board would not have fit.
Add some supports at the bottom in order to print it without problems
I also had make the box a little bit higher as the Zigstar-Board would not have fit.
Add some supports at the bottom in order to print it without problems
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!