MakerWorld
Gadgets
Zum Modell
ZimaBlade dual SSD-Case
10
Downloads
2
Likes
3
Makes
Notes on printing:Orientation so that the flat side (inside) lies on the print bed. Optional possibility to glue in TPU feet. Minimal support required.Assembly:Screw the printed parts to the two hard disks using 8x M3x8 screws. Then simply insert the ZimaBlade into the recess at the top. When I print, the ZimaBlade “snaps” into the print.PS: I haven't printed or used the feet yet, so I can't say anything about the accuracy of fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!