Thingiverse
Zine Rack
di interfect
4
Download
9
Likes
0
Makes
This is a rack for holding mini-zines! You insert the lower left corner, where the spine is, into the rack, and it holds them so people can see them and they don't spring open and wander all over your table.
The "Zine Rack Pincher Angled Shallow" holds zines at a 30 degree angle, so they're easy to see from a table. It's the latest and greatest version! You might want to print it on its side, since the rounded corner prints fine in that orientation and printing it right-side up I had some trouble with the bottoms of the separators between the slots not adhering to the bed well enough.
The "Zine Rack Pincher" holds zines sitting vertically. It works, but I noticed it was a little hard to see the zines when standing above the table the rack is on.
The "Zine Rack Pincher Angled Shallow" holds zines at a 30 degree angle, so they're easy to see from a table. It's the latest and greatest version! You might want to print it on its side, since the rounded corner prints fine in that orientation and printing it right-side up I had some trouble with the bottoms of the separators between the slots not adhering to the bed well enough.
The "Zine Rack Pincher" holds zines sitting vertically. It works, but I noticed it was a little hard to see the zines when standing above the table the rack is on.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
