Zing Orbit Foam Core Table Clip

a clip that will attach to the Zing Orbit to hold a standard 5mm foam core piece on the front and back of the machine in lieu of the tables

You'll need one of these screws for each you print (recommend 3 each for front and back, though you can do up to 5)

https://www.amazon.com/dp/B01HSTUO1K/ref=as_li_ss_tl?coliid=I3LAPFI7CMRK25&colid=DMT89LB6MJT2&psc=1&ref_=lv_ov_lig_dp_it&linkCode=sl1&tag=gamersvoice-20&linkId=6a7e758415e7f0ea6aee57f1f6aa6c46&language=en_US

Should be printed on edge as shown for strength. No supports required. I used .40mm layer height just fine, but you could do smaller if you like.

You might need to rotate to compensate for motion if your print bed moves during printing (vs. only the extruder).