Thingiverse
Zip tie mount [30 mm]
door ilko
498
Downloads
274
Likes
0
Makes
**This is for reference, [v2 is here](https://www.thingiverse.com/thing:7006052)**
Re-Remix, as requested. Special thanks to [Spoown](https://www.thingiverse.com/spoown) & [AdamLss](https://www.thingiverse.com/adamlss) for their help in tesing this.
This doesn't require support and is easy to place and remove by rotating it at 90°.
A little warning though, the T hook can be fragilized if you rotate it too much times. If it's too hard to put in place (making it brake, or vice versa), scale the object down or up by increments of 0.01%.
It should fit well with PETG.
Designed for 30XX extrusion profiles.
Ø 0.4 nozzle recommended settings :
Max layer height : 0.15
Wall lines : 3 (1.2 mm)
Infill : 20-100%
**Note : this a reupload because the full zip was unavailable and stats were broken.**
Re-Remix, as requested. Special thanks to [Spoown](https://www.thingiverse.com/spoown) & [AdamLss](https://www.thingiverse.com/adamlss) for their help in tesing this.
This doesn't require support and is easy to place and remove by rotating it at 90°.
A little warning though, the T hook can be fragilized if you rotate it too much times. If it's too hard to put in place (making it brake, or vice versa), scale the object down or up by increments of 0.01%.
It should fit well with PETG.
Designed for 30XX extrusion profiles.
Ø 0.4 nozzle recommended settings :
Max layer height : 0.15
Wall lines : 3 (1.2 mm)
Infill : 20-100%
**Note : this a reupload because the full zip was unavailable and stats were broken.**
ilko publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!