Thingiverse
Zip Tie
von techno_letsgo
100
Downloads
45
Likes
0
Makes
Hi!
This is a functional 3D printable ziptie, originally from seajseven.
Works with PLA filament and .2 mm layer height, the ziptie comes in 3 different sizes, 120mm, 150mm, and 200mm.
I remade the original design to have even bigger teeth and I've tested it and it works great. Depending on what plastic you use, the tie will break if tied too tight, but will probably work well regardless.
I hope you enjoy it!
This is a functional 3D printable ziptie, originally from seajseven.
Works with PLA filament and .2 mm layer height, the ziptie comes in 3 different sizes, 120mm, 150mm, and 200mm.
I remade the original design to have even bigger teeth and I've tested it and it works great. Depending on what plastic you use, the tie will break if tied too tight, but will probably work well regardless.
I hope you enjoy it!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
