Thingiverse
zip tie wall holder
von rafacoval
2
Downloads
1
Likes
0
Makes
Just a little zip tie holder to stick in wall's with double sided tape. super easy and chip to print. fast and easy.
i searched and don't find nothing that i liked, easy and clean, so decided to waste 1 mint in fusion and draw this, so i'm sharing this model so other may need it too.
It uses that small zip-ties for eletronics. +/- 3mm width.
V2 have a bigger contact area for better adhesion and have a more smooth look.
i searched and don't find nothing that i liked, easy and clean, so decided to waste 1 mint in fusion and draw this, so i'm sharing this model so other may need it too.
It uses that small zip-ties for eletronics. +/- 3mm width.
V2 have a bigger contact area for better adhesion and have a more smooth look.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
