Thingiverse
Zippo Lighter Case
door Geekdad_3D
86
Downloads
81
Likes
0
Makes
I created a Zippo lighter case for the standard size lighter. It was inspired by https://www.thingiverse.com/thing:4222731 but I started from scratch to make it fit better. It uses a piece of 1.75mm filament (or similar) for a hinge pin. In my opinion it is best on a resin printer as the hinge breaks too well.
Geekdad_3D publiceert ook op
251 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
