Thingiverse
ZMR 180 Lowrider conversion
door r08813
0
Downloads
0
Likes
0
Makes
Having never been happy with the ZMR 180 frame, as it is too high, and ungainly, I decided to go for a lowrider look. By removing the camera and vtx from the main body I was able to fit a Naze32, PDB, 4 esc's and the receiver in the enclosed part. making this a very tidy (but tight) build.
The camera part is supported by the original standoffs, but the body is now held together with m3 bolts.
The top of the camera housing has slots for velcro straps to hold a mobius or similar.
The first print in PLA proved a little fragile in high speed crashes, but with a few areas thickened and now printed, works well in ABS.
Initial flight testing on Cleanflight standard PID's appears OK, but much improved with tuning.
The usb access point is designed for a Naze32 rev6, above a standard PDB, Motors are DYS 1306 3100Kv, esc's 16a
The back of the camera section has small tubes to hold the antenna. There are two options for fpv cameras as my initial camera was an eachine 1000tvl, bu
The camera part is supported by the original standoffs, but the body is now held together with m3 bolts.
The top of the camera housing has slots for velcro straps to hold a mobius or similar.
The first print in PLA proved a little fragile in high speed crashes, but with a few areas thickened and now printed, works well in ABS.
Initial flight testing on Cleanflight standard PID's appears OK, but much improved with tuning.
The usb access point is designed for a Naze32 rev6, above a standard PDB, Motors are DYS 1306 3100Kv, esc's 16a
The back of the camera section has small tubes to hold the antenna. There are two options for fpv cameras as my initial camera was an eachine 1000tvl, bu
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!