Thingiverse
ZMR250 Micro FPV Camera Mount
door marcotheboy
10
Downloads
5
Likes
0
Makes
This allows you to mount a micro FPV camera with 19mm width (eg, Runcam Micro Eagle) to a ZMR250 frame.
Screw the camera to both pieces and slide the whole thing onto the 35mm standoffs.
You can easily adjust the tilt of the camera via the 2 screws.
Both pieces are identical (just mirrored).
The 1st stl file prints both pieces at the same time (1mm apart).
The 2nd stl file prints just one piece (you may need the part cooling fan on to print this).
The 3rd stl file is both pieces with the camera positioned 5mm lower (in case you need to tilt the camera upwards a lot)
This should work with any camera that is 19mm wide.
Screw the camera to both pieces and slide the whole thing onto the 35mm standoffs.
You can easily adjust the tilt of the camera via the 2 screws.
Both pieces are identical (just mirrored).
The 1st stl file prints both pieces at the same time (1mm apart).
The 2nd stl file prints just one piece (you may need the part cooling fan on to print this).
The 3rd stl file is both pieces with the camera positioned 5mm lower (in case you need to tilt the camera upwards a lot)
This should work with any camera that is 19mm wide.
marcotheboy publiceert ook op
5 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
