Thingiverse
ZMR250 side cover
por Nilz
120
Descargas
75
Likes
0
Makes
I created a side cover for the ZMR250. It was a tight fit, but works well! There is a small gap between the side cover and the top frame near the FPV camera because of the piece holding the camera. Not much I can do about it. This won't fit if you have a Naze32 with pin headers sticking out the side. Solder the servolead for the receiver directly to the board.
If anyone wants pattens or whatever, leave a coment so I can add them. Source is from Inventor 2015 (student edition).
Print upside down (flip z-axis)!
Have fun!
If anyone wants pattens or whatever, leave a coment so I can add them. Source is from Inventor 2015 (student edition).
Print upside down (flip z-axis)!
Have fun!
Nilz también publica en
13 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!