Zombie wine pourer

This is meant to fit in the mouth of a wine bottle, allowing the wine to pour through, out of the zombie's mouth and right eye.

It is split into two pieces for easier printing. I used tree-supports for the head, which removed easily. The bottom required no supports when oriented with the widest side facing down.

There is a notch for an o-ring to fit for a better seal, but it seems possible to wedge it in tight enough for use if you're careful and watch to make sure it doesn't fall out while pouring.

The hole through the head is meant for a straw to pass air back into the bottle, so the pouring wine doesn't gurgle from the vacuum it creates. Push a plastic straw into the bottom of the head before gluing the two halves together. It doesn't have to go all the way through the head - just far enough to stay in place. The bottom is then passed over the straw when it is glued in place.

I intend for mine to be a single use item, since I can't imagine how to clean this well eno