ZSA Navigator Trackball Moonlander Shells

A collection of ZSA Navigator shells to use with your Moonlander!The 3MF file contains 4 different plates, each with a different configuration you can choose depending on what hand you would like the trackball on and whether you would like it below or above the thumb cluster. You only need to print 1 plate. You can also refer to the STL files directly. All configurations also come with a “wedge” to give the other half of your Moonlander the same tenting angle (20 degrees or so). All pieces can be mounted to the back of the Moonlander with 4 M2.5x5 screws per side. Moonlander Navigator Thumb ShellThis design puts the trackball underneath the thumb cluster, more in reach of your thumb. You can also use your palm, but this may be less precise. Note that the default short TRRS cable that comes with the Navigator is slightly too short to reach the Navigator all the way down here from the Moonlander's TRRS port. So, the print instead accommodates a right-angle TRRS connector so you can u