Thingiverse
Zynthian Case
door Axeman72
35
Downloads
18
Likes
0
Makes
This is a fully printable case for the fantastic Zynthian project:
http://zynthian.org/
All visible parts are rotated so that the external side is the first layer (on a glass bed this make a fantastic look).
Overhang are less than 45° so all parts should print without support.
You can thread (M4) holes on the tabs in left and right side, or glue nuts in place.
(Yes, I know, screw holes on the back panel are almost out of the tabs... I'll fix that ASAP)
http://zynthian.org/
All visible parts are rotated so that the external side is the first layer (on a glass bed this make a fantastic look).
Overhang are less than 45° so all parts should print without support.
You can thread (M4) holes on the tabs in left and right side, or glue nuts in place.
(Yes, I know, screw holes on the back panel are almost out of the tabs... I'll fix that ASAP)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
