ZYX Cartridge Reprogramming Boot

There are posts out there to such as this (https://www.voltivo.com/da-vinci-1-0-filament-counter-reset-using-an-arduino/) to reset your printer cartridge counter. However, holding the wires to the cartridge while you're holding the arduino and the power is difficulty.

Thus, here is a boot that you can wire up and just plug the arduino as shown, so that when you're ready to reset your counter you just set your cartridge in the boot.

Tip: I used 24 gauge wire, which I pulled through the holes with leader thread (to thread the thread through, I just put the tip of the thread in one end of the hole, and sucked it through the other).