Slicer Discord
1 Byte Binary Abacus – 3D-Druckmodell von MakerOnline MakerOnline
1 Byte Binary Abacus – Bild 1 1 Byte Binary Abacus – Bild 2 1 Byte Binary Abacus – Bild 3
Education

1 Byte Binary Abacus

15 Downloads
8 Likes
0 Makes
Zum Modell
     This is a binary abacus. Binary code is the type of code computers use to read numbers. They use powers of two and 0's and 1's to show numbers. For example, the last picture shows 01010010, as you read it from left to right. 01010010 is 82, as there is a 2, a 16, and a 64.         Sorry about the blurry photos, my iPad does not have a good enough camera.         To assemble, you slide the dowels into one of the holes, notch up. It is meant to be tight, so you may have to put some force in. Then, you slide a bead over the dowel, then place the other end of the dowel into the corresponding hole.   If you print it all in one color, like I did, make sue to paint the beads, notch, and numbers afterwards
Kategorie
Education
Quelle
MakerOnline
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Bemalen
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen