101Kossel Conversion

This is an attempt to convert the $99 101Hero Kickstarter printer into a modified Kossel Mini reusing as many of the 101Hero components as possible printed on the 101Hero (Size restrictions less than 110mm diameter and less than 100mm tall).

Note: This does require upgrading the tower motors to NEMA17 but it should be possible to reuse all other components (extruder, belts, steel rods, push rods, linear bearings, controller, etc.)

Current 3D Printed BOM:
3 frame top
3 frame bottom
33 75mm 2020 rails
54 rail connectors (M3 or M4)
90 25mm inner-fill
3 or 6 end caps (optional)

Extra hardware:
54 M3 or M4 nuts (size determined by rail connectors)
54 M3 or M4 x 4mm screws

36 M5 nuts
36 M5x10 hex bolts
If you want to use M3 or M4 bolts, I have included T-Nut models for M3 and M4 nuts. Washers may be required for smaller bolts.