Thingiverse
110 Quadcopter/Drone Frame
por xlitec13
11
Descargas
13
Likes
0
Makes
A minimal size 3D printable frame for 3 inch blades (can't go smaller than 110mm for clearance reasons).
The frame is designed to fit most 1102-1407 brushless motors and has built in 20mm mounting holes for the electronics. The printed frame is 11-25g, depending on perimeter settings, infill settings, and filament type.
There is no battery mounting hardware designed in.
This frame is untested as I don't have the parts for a 3" quadcopter. If you do print and build on this frame, let me know how well it goes!
The frame is designed to fit most 1102-1407 brushless motors and has built in 20mm mounting holes for the electronics. The printed frame is 11-25g, depending on perimeter settings, infill settings, and filament type.
There is no battery mounting hardware designed in.
This frame is untested as I don't have the parts for a 3" quadcopter. If you do print and build on this frame, let me know how well it goes!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
