dewalt 611 router table

i made this table on my shapeoko2 1000mm all parts were made in sketchup and used sketchucam for tool paths the dewalt mount is also made in a stl version if you want to 3d print that part i used 1/4 acrylic sheet. the frame was made out of 1/2" mdf i used sheet rock screws and pre drilled holes, also had to counter sink bit to make screws flush so no hangups.
i have all parts in the skp file sketchup and sketchucam are free programs and work well, note sketchup crashs a lot so save often