Thingiverse
Da Vinci 1.0 to Dual Bowden E3D V6
49
Downloads
28
Likes
0
Makes
Experimental parts for a Da Vinci 1.0 to RAMPS 1.4 conversion
My previous part (http://www.thingiverse.com/thing:1188315) was going to reduce the X printing area by a lot, so this part has one hotend in front of the other instead of side-by-side.
I'm also replacing the entire X carriage this time.
v3 uses new bearings (LM8UU)
v4 has longer screw holes
My previous part (http://www.thingiverse.com/thing:1188315) was going to reduce the X printing area by a lot, so this part has one hotend in front of the other instead of side-by-side.
I'm also replacing the entire X carriage this time.
v3 uses new bearings (LM8UU)
v4 has longer screw holes
Sign in to leave a comment
Sign in